Questions & Answers

INT-SL+ not programming on 05 sequoia.

0 votes
Int-sl+ not responding when hit the lock button.  Red light just stays on.. no flashing, no nothing.  Any idea? It's flashed to firmware  0.17
asked Jan 15 in Toyota by Gdry06 (130 points)
edited Jan 15 by Gdry06

1 Answer

0 votes
Hello,

Only time I have seen them do this is when you are not on the correct door lock data wire.

 

On this vehicle should be in the driver kick, gray 13 pin connector, pin 3, white/blue.

 

If any type of quick connect was used (t-tap, posi tap etc) please remove it and make a proper spliced connection.

 

Best regards.
answered Jan 16 by derek g (346,810 points)

Related questions

...