Questions & Answers

Blue Light Flashing After Programming

0 votes
I have a Jerp Commander 2007, followed instructions. Added yellow cable, everything went smooth with programming, till the point where u take key out and hit lock button. After that blue led light just flashes and won't start the vehicle. Any ideas?
asked Apr 9, 2017 in Jeep by Gino Rocha (160 points)

1 Answer

0 votes
Leave options A1 to A11 to ON and retest.
answered Apr 10, 2017 by Gino Rocha (85,190 points)
Looks like it works, but Jeep will not start. Diagram says to add a hood pin. Not sure if this will prevent it from working. Sounds like something starts to happen but vehicle will not crank. Not as easy as they claim it is.

Thanks for your help.
looking at your service number options a1 to a11 are still not all ON, please enable these options and retest.

 

Also, please verifiy that if there is a starter wire in pin 2 of the ignition harness, you will need to follow connection F
...