Questions & Answers

2012 Ford Fusion SEL - Cannot get Remote Start to Work

0 votes

Building further onto my previous question:

I have completed the EVO programming with the dcryptor and it says it successfully programs.  I am using the latest firmware and software.  When I plug the EVO back into the vehicle and prss the lock button x3 it will not start the vehicle.  I can see on the EVO the blue lights flash when I hit the lock buttons, but that is all it does.  I have the options set in the module for 3x lock to start it.  I made sure the CANBUS wires were making contact and tight.  I tried to reprogam again last evening and still not starting.

Any thoughts on how to get this to remote start my 2012 Fusion?

asked Dec 12, 2018 in Ford by davidtown23 (190 points)

2 Answers

0 votes
Your option 3x lock is not enabled. You must enable D1.10
answered Dec 12, 2018 by Mathieu Bertrand Collin (62,040 points)
Thanks

I will try that as soon as I can get it back onto the computer
0 votes
Also make sure you reprogram the 2 functional keys each time you remove the module. I ran into the same problem when programming my wifes 2012 ford fusion.
answered Dec 22, 2018 by Gary Fowler (480 points)
Is the dcryptor step required on the 2012? Trying to do one now and the first key i get red and yellow light 2nd i only get red and after removing the key and pressing the button nothing happens aside from the security light flashes
Nevermind... figured out that my can splice was not good. Threw the scotch locks away and did it right and all is good now
...