Questions & Answers


0 votes
2013 Equinox will not start. EVO-ALL. did the press 5 times programming, unplugged, went to the computer and finished programming. installed back into vehicle. blue light flashes 3 times by pressing lock 3x's, red light comes on steady, blue light briefly comes on. red light flashes roughly 10-12 times. red light stays on, then goes off. yellow light comes on steady and stays on. while all of this is going on the door chimes, door locks, and radio all come on as if the car was going to start. almost forgot to mention i did get the car to start one time. however, it never worked again. service number is 001A06835311. back of unit also says evo ford, evo mazda pre-loaded. is it possible that i was sent the wrong kit? box says equinox on it.
asked Mar 15, 2019 in Chevrolet by tony tedesco (160 points)
reopened Mar 15, 2019 by Robb

1 Answer

0 votes

couple of things have gone wrong here. 

-- Firmware does need to be updated to 4.12 according to the date of production and the latest installation guide. 

-- The options in the unit are improperly set up. 


To solve all this...

1. Reset the EVO:

2. Flash firmware 4.12

3. Turn ON appropriate options (C1 + D1)

4. Reprogram unit to vehicle and redo the Dcryptor process.

answered Mar 15, 2019 by Robb (236,080 points)