Questions & Answers

Do you have a wire diagram to connect a Viper 5806V and Fortin EVO-CHRT5 together?

0 votes

I am getting ready to install a Viper 5806V and Fortin EVO-CHRT5 together in a 2015 Jeep Wrangler JK and am curious on some of the wiring for connecting the two. So do you have a wire diagram to connect a Viper 5806V and Fortin EVO-CHRT5 together for this vehicle?

 
asked Mar 26, 2019 in Jeep by Roger Hovis (160 points)

1 Answer

0 votes
answered Mar 27, 2019 by derek g (324,940 points)
Ok thanks. Just so I get this straight with it while I am looking at it. The Viper has an in and a out wire that connects to the vehicles starter wire after you cut it. So just tape up the in wire of the viper and connect the fortin to the out wire of the viper? Also the "ground out while running" wire that connects to the "status output" of the viper correct?
If you are connecting the 2 modules wire to wire, connect all the dotted lines between the viper and the evo as shown in the guide.

 

If using the data link between the 2 units then you do not need the dotted lines.
...