Questions & Answers

Drone Mobile (DR-5400) Questions

0 votes
I've finished my EVO-ONE (MAZ30 harness) install.  Everything works great.  I also installed the DR-5400 and it also works perfectly (swapped the two wires in the harness and rolled back to 0.50 firmware, YES it retained all the previous remote starter settings from the higher firmware).

Two questions.  Can I reinstall a later firmware at some point?  I know this was in the works.

Also, how can I get the trunk button to work on drone mobile?  I know it wont work while it is in remote start on mode, but, it wont work from the app while the car is off and doors unlocked.  It works just fine on my friend's drone mobile app with his compustar.
asked Oct 14, 2019 in Mazda by Marc Glogovsky (160 points)

1 Answer

0 votes

"Can I reinstall a later firmware at some point?"

- as of now, No you cant. 

 

"ow can I get the trunk button to work on drone mobile?  I know it wont work while it is in remote start on mode, but, it wont work from the app while the car is off and doors unlocked"

- you would have to wire in the evo's aux output, yellow/black on the 20 pin connector, to the vehicles liftgate wire. 

answered Oct 15, 2019 by derek g (324,940 points)
...