Questions & Answers

2011 tundra just cranks. Using Evo one with toy7 harness and Evo start2.

0 votes
Installed Evo one with Evo start 2 mobile using tharness toy7 on a 2011 tundra h-key. All settings set up correctly. Tapped into key sense wire for factory alarm and tapped yellow wire from mobile antenna to pink wire on ignition harness. Unable to program the remote that comes with it and when I remote start with factory key fob car just cranks...it starts if I put the key in the ignition but then I am unable to turn Off the car without unplugging the Evo one. Any ideas?
asked Nov 17, 2019 in Toyota by Michael Pugiotto (150 points)

1 Answer

+1 vote
Check that option 2.4 in the remote starter settings is enabled. For remote programming, press unlock on your oem first to disarm the evo or else it wont let you program anything.
answered Nov 17, 2019 by Robert T (297,620 points)
Option 2.4 is enabled ...checked multiple times. Wondering if the module or t-harness is at fault
service number of the module?
002B04 043602
check your Bypass options, all the default ON options were turned off.  The key bypass option is off, turn it back on.

 

enable...

A3 and A7

 

If the unit was programmed in the with A3 OFF,  you will probably also need to reprogram it.
Thanks, options changed and working fine. Not sure what happened but all is good now! Thanks again
...