Why am I getting 3 red LED blinks after step 7?

Question

UPDATE: I plugged everything in and gave it a try. Car starts right up but dies immediately. Gives me the "no key" alert. dcryptor process will not complete for some reason.

 

2013 Passat standard key, standalone install. EVO-ALL (2/2019), THAR-VW2, and TB-VW (1/2017).

Guide 62471

SN: 001A07 008702

Flashlink Firmware: 75.39

TB-VW wired into brown transponder wire.

I have all of the harness installed as directed but when I start the dcryptor programming, all goes beautifullt until the end of step 6. When I release the programming button, I don't get the rapid 3-LED alternation. The red LED just continuously blinks 3 times. I've even tried resetting the

Answer 1

3 red flash is vehicle unknown. You will want to go over your CAN2 connections. 

Also, reset the evo. https://fortin.ca/en/qa/50193/faq-how-do-i-reset-my-evo-all?show=50193#q50193

Comments

What voltage should I be getting at the CAN2 connections?

I checked the resistance from the OBD to the CAN2 connector. Everything is great there - no resistance.

I reset the EVO as directed in your link but I still get the triple red flash at the end of step 6. Am I doing something wrone in flash link? Everything there shows my exact vehicle. I ran pro version and saved the suggested options. What am I missing here?

---

it would be an even split of 5Vdc. Meter them directly at the evo connector to ensure connections are good. And, check that the wires are simply not reversed.

---

Voltage there is good. Split 5v. Still getting the 3 red flashes. Am I doing something wrong in flash link? Everything there shows my exact vehicle. I ran pro version and saved the suggested options. What am I missing here?

 

---

proably diagrams to obd connector is wrong - change can hi to can low