2003 volkswagen jetta tdi- no CAN input data after successful programming

Question

using evo-one with rfk-441.

regular installation (no t-harness), firmware and software update with guide standards. successful programming in last step (blue blink key on).

\this vehicle has immo delete (metal key blade starts)

now when trying to program remotes no brake input detected to perform remote programming.

performed reset and even went as so far to swap evo one units. am i using wrong firmware or hardwire brake input?

Answer 1

Hello,

That can happen when cars are modified such as immo delete.

Probably would be just easiest to hardwire the brake wire, its the black wire on the 20 pin connector of the evo, connect it to the wire at the brake switch that has 12v brake depressed and 0v brake released.

Best regards