Questions & Answers

Security light (demobilizer light on ) After unsuccessful Evo all install

0 votes
After many failed attemp with tech support today to install my EVO. Now my security light is permanently on after I removed all the EVO harness and Evo All. The car starts and runs so far. Please I hope there is something I can do since going to the dealer for demobilizer problem is easily a $590 dollar bill.  I believe the evo must have changed my security settings.
 
Below was the original install issue. I have decided to take the vehicle to a shop for a fresh install with a fresh unit and system but I have to have the security light back to normal or they wont touch the car.
 
----------------------------------------------------------------------------------------------------------
 
Car 2011 QX56

EVO-ALL & THAR-NIS1 Stand Alone Service # 001 A06 585175

Guide #12681

During programing when I get to #7 The red sometimes turns off and only blue is on. I have only been able to get both red and blue to stay on twice very briefly.

In the instances when they stayed on, following the next step #8, Pressing the start and stop button x2 does not turn on the ignition. If you press it a third time or jump to #9 the the inginition turns on and it flashes rapidly. If I go  continue with the programing, the result is that the car does not remote start on pressing 3 times. Basically nothing happens, it simply locks the door 3 times.

I have an updated firmware. Did the update all over again yesterday successfully. I have been on this thing for the past 2 days. Have not done anything else all weekend.

I am at my wits end with this thing. Somebody help.
Service Number : 001 A06 585175
asked Feb 2, 2016 in Infiniti by Frankie Aladi (160 points)
edited Feb 2, 2016 by Frankie Aladi

1 Answer

+1 vote
You have removed the t-harness and the light is still on ?

EVO does not change any immobilizer settings in your car, I would verify all fuse in the vehicle and try to disconnect and reconnect the battery. Also make sure the 4 pin connector and the start button is inserted properly.
answered Feb 2, 2016 by Frankie Aladi (85,210 points)
 
0votes
 
Yes I have removed the t- harness and the light is still on.

Connect and disconnect battey does not work. I have tried that twice plus as per web research disconnecting and connecting battery does not work for security light on infinity 

All pins are inserted properly.

I have driven the vehicle but the security light is permanently on now.

 

All is well now. It reset itself overnight. This from someone else might also she'd some light.https://fortin.ca/en/qa/54443/security-light-stays-on-after-start-the-vehicle

...